0 기록(들)
We found results matching "0" in 0 ms
  • Sonoff Dual R2 2CH Wifi Switch

    시간: Mar. 31, 2020

    Sonoff Dual R2 is the replacement for Sonoff Dual. Compared to the dual, the main improvements for R2 are:

     

    * Since the removal of the second microcontroller, the two relays are now directly controlled by an ESP8285
    * The button is now directly connected to the ESP8285
    * Header connector now supports Tasmota

     

    Sonoff Dual R2 series flashing
    As always, you must access the serial interface. VCC, RX, TX and GND are available at the bottom left of the card in the image below.

     

     

    Programming the Sonoff Dual R2 is very easy, even if the integrated button is not connected to GPIO0. As with all ESP8266 / ESP8285 modules, GPIO0 must be connected to GND to put the chip into programming mode. You must connect GPIO0 and GND when powering on.

     

    Fortunately, GND and GPIO0 (like KEY 0) are available in the second header. A simple jumper between GND and BUTTON 0 when turned on is sufficient.

     

    You can find a video about flashing the Sonoff Dual R2 with Tasmota here.

     

    Use external switches
    Relays can be controlled by external buttons or switches connected to the header at specified positions. KEY 0 (for GPIO0) connected to the GND 1 controller relay and KEY 1 (for GPIO9) to the GND 2 controller relay.

     

    NOTE Make sure that you are not using a switch that keeps the connection between GND and KEY 0 active during power restore, as the device starts in programming mode.

     

닫기bzfuture에 오신 것을 환영합니다. 로그인하세요.

아직 가입하지 않으셨나요?   지금 가입하세요

타사 계정으로 로그인:

  • google
  • Twitch
  • Youtube

닫기bzfuture에 오신 것을 환영합니다. 가입하세요.

  • 이메일 주소 *(Used To Receive Key)

    유효한 이메일을 입력하세요.

  • 비밀번호*

    6~16자의 문자, 숫자, 특수 문자.

  • 비밀번호 확인*

  • 이름* *

  • 읽고 동의했습니다. 
    bzfuture의 할인 혜택, 이벤트 및 뉴스레터를 구독하세요.

이미 bzfuture 계정이 있으신가요?   지금 로그인하세요

타사 계정으로 로그인

  • google
  • Twitch
  • Youtube

닫기

프롬프트:

increase-the_programe_has_been_successfully

닫기

프롬프트:

increase-the_programe_has_been_successfully

닫기

프롬프트:

시스템이 부하상태입니다. 잠시만 기다려주세요

닫기등록 성공

닫기보안인증

You have an unextracted key !
장바구니에 새 항목이 추가되었습니다.